Commands In The Interface Configuration Mode; Ipv6 Address - Siemens SCALANCE XM-400 Configuration Manual

Syntax
Call the command without parameter assignment:
no ipv6 unicast-routing
Result
IPv6 routing is disabled. On interfaces on which IPv6 is enabled, stateless autoconfiguration
is performed.
Further notes
You enable IPv6 routing with the
You display the IPv6 routing table with the
7.2.4

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
7.2.4.1

ipv6 address

Description
With these commands, you assign an IPv6 address to the interface. The IPv6 address can
be assigned to the IP interface manually or by prefix delegation.
With prefix delegation, the IP interface becomes a DHCPv6 PD sub-client. This forms its
IPv6 address from the prefix name, the prefix and the prefix length.
Requirement
● IPv6 is activated
● The interface is an IP interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
ipv6 unicast-routing
show ipv6 route
command to change to this mode.
interface
exit
end
Network protocols
7.2 IPv6 protocol
command.
command, you return to the
command, you return to the
319