Configuration
3.1 System
Further notes
You can reset the duplex mode of the Interface to the default value with the
command.
You disable autonegotiation with the
3.1.13.6
no duplex
Description
With this command, you reset the duplex mode of an interface to the default value.
The default value is
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no duplex
Result
The duplex mode of the Interface is reset to the default value.
Further notes
You configure the duplex mode of the interface with the
3.1.13.7
lldp
Description
With this command, you enable the sending and receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
96
no negotiation
.
full
command.
command.
duplex
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
no duplex