Nfc (Scalance Xm-400 Only); The "Show" Commands; Show Nfc Active Status; Commands In The Global Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Configuration

3.6 NFC (SCALANCE XM-400 only)

3.6 NFC (SCALANCE XM-400 only)
3.6.1

The "show" commands

This section describes commands with which you display various settings.
Note
You will find further information on NFC in the operating instructions "SCALANCE XM-400".
3.6.1.1

show nfc active status

Description
This command shows whether or not the NFC function (Near Field Communication) is
activated or deactivated.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show nfc active status
Result
The status of the NFC function is displayed.
3.6.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
140
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command and are then in the