Output-Delay; Commands In The Interface Configuration Mode - Siemens SCALANCE XM-400 Configuration Manual

Result
Both RIPv1 and RIPv2 packets are processed.
9.6.3.13

output-delay

Description
With this command, you configure the delayed forwarding of RIP updates.
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call up the command with the following parameters:
output-delay <milli-seconds(8-50)>
The parameter has the following meaning:
Parameter
milli-seconds
Result
RIP updates are forwarded only after the set delay.
9.6.4

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Delay in milliseconds.
interface
Layer 3 functions
9.6 RIPv2 (IPv4)
Range of values / note
8 ... 50
command to change to this mode.
command, you return to the
exit
command, you return to the
end
687