Monitor Session Source - Siemens SCALANCE XM-400 Configuration Manual

Diagnostics
12.4 Port Mirroring
Result
The destination for the mirroring of a port is deleted.
Further notes
You configure the destination for mirroring a port with the
command.
You end and delete a session with the
You display the configuration settings with the
12.4.2.7

monitor session source

Description
With this command, you configure the source for mirroring a port or a VLAN.
Requirement
● Monitoring is enabled.
● You are in the Global configuration mode
.The command prompt is:
cli(config)#
Syntax
Call up the command for the port to be monitored with the following parameter assignment:
monitor session<session-id(1-7)> source
{interface {<interface-type><interface-id> | port-channel <port-channel-id (1-8)>}
[{rx|tx|both}]}
or
Call up the command for the VLAN to be monitored with the following parameter assignment:
monitor session <session-id (1-1)> source
{vlan <vlan-id> | mac-acl <acl-id>} | ip-acl <acl-id>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-type
interface-id
930
no monitor session
show monitor session
Description
Number of the session
7 parallel sessions are possible only
with port-based mirroring and their
ports must not overlap.
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
monitor session ... destination
command.
command.
Range of values / note
1 ... 7
-
Enter a valid interface.
Configuration Manual, 06/2016, C79000-G8976-C252-11