Show Ipv6 Mld Snooping Globals - Siemens SCALANCE XM-400 Configuration Manual

Requirement
● MLD snooping is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 mld snooping groups [Vlan <vlan id> [Group <Address>]]
The parameters have the following meaning:
Parameter
Vlan
vlan id
Group
Address
If you do not select any parameter from the parameter list, the configuration is displayed for
all interfaces.
Result
The information on the MLD snooping group is displayed.
Further notes
You enable MLD snooping with the
8.8.1.4

show ipv6 mld snooping globals

Description
This command shows general information on MLD snooping for the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for an MLD snooping group
Address of the MLD snooping group
or
cli#
command.
ipv6 mld snooping
Layer 2 management protocols
8.8 MLD Snooping (IPv6)
Range of values / note
-
1 ... 4094
-
Enter a valid address.
499