No Redist-Config - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Call up the command with the following parameters:

redist-config <Network> <Mask>

[metric-value <metric (1 - 16777215)>]

[metrictype {

asExttype1 | asExttype2

The parameters have the following meaning:

metric-value

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The information for the route is specified.

Further notes

You remove the information with the

You distribute the routes with the

no redist-config

With this command, you delete the information for the new external routes.

This command is available only with layer 3.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Target address of the route.

Subnet mask of this route

Keyword for the metric of the route

Keyword for the connection costs

no redist-config

Layer 3 functions

9.2 OSPFv2 (IPv4)

Range of values / note

enter the IPv4 address.

specify the subnet mask.

1 - 16777215

External and internal costs

External costs