Set Metric - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.8 Route maps (IPv4 / IPv6)

set metric

With this command, you specify whether the routing information is forwarded with a changed

This command is available only with layer 3.

You are now in the Route maps configuration mode.

The command prompt is as follows:

cli(config-rmap-$$$)#

Call up the command with the following parameters:

set metric <value(0-0xffffff)>

The parameter has the following meaning:

The routing information is forwarded with a changed metric.

Further notes

You delete the setting that the metric of the routing information is changed with the

You change to the Route maps configuration mode with the command

You display the setting and other information with the

Value of the metric

Range of values / note

0 ... 0xffffff

Enter the new value for the metric with which the routing

information will be forwarded.

You can enter the value in decimal or hexadecimal.

show route-map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11