Ipv6 Unicast-Routing; No Ipv6 Unicast-Routing - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
7.2.3.9

ipv6 unicast-routing

Description
With this command, you enable IPv6 routing on the device.
Note
IPv4 routing
If IPv4 routing is not enabled on the device, this is also enabled with this function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipv6 unicast-routing
Result
IPv6 routing is enabled.
Further notes
You disable the IPv6 routing with the
You display the IPv6 routing table with the
7.2.3.10

no ipv6 unicast-routing

Description
With this command, you disable IPv6 routing function on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
318
no ipv6 unicast-routing
command.
show ipv6 route
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.