Commands In The Global Configuration Mode; Mac-Address-Table Block Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.7 Multicast
8.7.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
8.7.2.1

mac-address-table block static multicast

Description
With this command, you configure static multicast addresses that will be blocked.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table block static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
address
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The settings for static multicast blocking are configured.
494
configure terminal
Description
Keyword for a VLAN connection
Number of the VLAN
Keyword for a MAC address
MAC address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
command to change to this mode.
or command and are then in the
end exit
Range of values / note
-
1 ... 4094
-
aa:aa:aa:aa:aa:aa
Configuration Manual, 06/2016, C79000-G8976-C252-11