Switchport Mode Private Vlan - Siemens SCALANCE XM-400 Configuration Manual

Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport mode
Result
The setting is reset to the default value.
Further notes
You configure the operating mode with the
You display this setting and other information with the
You configure the interface as a switch port with the
6.1.3.13

switchport mode private vlan

Description
With this command, you specify the operating mode for the private VLAN port.
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport mode private-vlan {promiscuous | host}
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
switchport mode
show vlan port config
command.
switchport
Network structures
6.1 VLAN
command.
209