Ip Address Dhcp - Siemens SCALANCE XM-400 Configuration Manual

Result
The IPv4 address is assigned to the VLAN interface or the router port.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, the connection will be lost!
Further notes
You delete the IPv4 address with the
You display this setting and other information with the
7.1.3.2

ip address dhcp

Description
With this command, the interface obtains the IPv4 address via DHCP.
Requirement
You are in the Interface configuration mode of VLAN or a router port.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
or with a router port:
cli(config-RPort-if-Int$-$)
Syntax
Call the command without parameters:
ip address dhcp
Result
The DHCP assigns the IPv4 address to the interface.
Further notes
You delete the settings with the
You display this setting and other information with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
no ip address
show ip interface
command.
no ip address
show ip interface
Network protocols
7.1 IPv4 protocol
command.
command.
303