Adding Bridge Multicast Address Members - Dell PowerConnect 3524P User Manual

Enabling IGMP Snooping on the device
1 Open the Global Parameters page.
2 Select Enable in the IGMP Snooping Status field.
3 Click Apply Changes.
IGMP Snooping is enabled on the device.
Enabling Multicast Filtering and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast Filtering and IGMP
Snooping as displayed on the Global Parameters page.
Table 7-38. Multicast Filtering and Snooping CLI Commands
CLI Command
bridge multicast filtering
ip igmp snooping
The following is an example of the CLI commands:
console(config)# bridge multicast filtering
console(config)# ip igmp snooping

Adding Bridge Multicast Address Members

The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service group
in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port or
LAGs joined the Multicast group. Ports can be added either to existing groups or to new Multicast
service groups. The Bridge Multicast Group page permits new Multicast service groups to be created.
The Bridge Multicast Group page also assigns ports to a specific Multicast service address group.
To open the Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast Group
in the tree view.
Description
Enables filtering of Multicast addresses.
Enables Internet Group Membership
Protocol (IGMP) snooping.
Configuring Switch Information
389