Deny (Management) - Dell PowerConnect 5324 Command Line Interface Reference Manual

• mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range: 0 - 32)
• service service—Indicates service type. Can be one of the following: telnet, ssh, http,
https or snmp.
Default Configuration
If no permit statement is present, the default is set to deny.
Command Mode
Management Access-list Configuration mode
User Guidelines
• Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is
defined on the appropriate interface.The system supports up to 256 management access
rules.
Example
The following example shows how all ports are permitted in the access-list called "mlist".
Console (config)# management access-list mlist
Console (config-macl)# permit

deny (management)

The deny Management Access-List Configuration mode command defines a deny rule.
Syntax
deny [ethernet interface-number | vlan vlan-id | port-channel number] [service service]
deny ip-source ip-address [mask mask | prefix-length] [ethernet interface-number | vlan vlan-
id | port-channel number] [service service]
• ethernet interface-number—A valid Ethernet port number.
• vlan vlan-id—A valid VLAN number.
port-channel number—A valid port-channel number.
•
• ip-address—Source IP address. (Range: Valid IP Address)
• mask mask—Specifies the network mask of the source IP address. (Range: Valid subnet
mask)
• mask prefix-length—Specifies the number of bits that comprise the source IP address
prefix. The prefix length must be preceded by a forward slash (/). (Range: 0 - 32)
191
Management ACL