Rep 9.14 Mob Sensor Assembly; Rep 9.15 Ibt Belt Assembly - Xerox DocuColor 1632 Service Manual

REP 9.14 MOB Sensor Assembly

Parts List on PL 1.3
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open Front Cover.
2. Remove Waste Cartridge (REP 9.4).
3. Remove Fuser Front Cover (REP 14.8).
4. Release and move Xerographic Release Lever half way down.
5. Remove Dispenser Assembly Cover
6. Remove Waste Toner Agitator (REP
7. Remove MOB Sensor Assembly (Figure
a. Open Harness Clip and remove harness from Clip.
b. Remove Screw and remove Inner Left Harness Cover.
c. Disconnect Harness P/Jís (3)
d. Remove MOB Sensor Assembly Harnesses (violet) from additional harness clips
(not shown).
e. Remove MOB Sensor Assembly Screw and pull out to remove MOB Sensor Assem-
bly. Xerographic Release Lever must be down as shown.
Harness
P/Jís (3)
Belt Mark
Sensor
Screw
Harness Clip
Screw
Inner Left
Harness
Cover
Figure 1 Removing MOB Sensor Assembly
Prelaunch Training/Review
DC1632/2240
WARNING
(REP 9.6).
9.13).
1).
Xerographic
Release
Lever

REP 9.15 IBT Belt Assembly

Parts List on PL 5.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open Front Cover.
2. Release and move Xerographic Release Lever down.
3. Open Right Side Door.
4. Remove IBT Belt Assembly (Figure
a. Lift to release Slide Lock.
b. Pull out IBT Unit to remove it. Use Handle to transport IBT Unit.
c. Protect IBT Belt Assembly from direct light.
Handle
Slide
Lock
Figure 1 Removing IBT Belt Assembly
6/02
4-79
WARNING
1).
Repairs and Adjustments
REP 9.14, REP 9.15