Table of Contents
Advertisement
Reinstall TX Matrix Plus Components
Step 4: Connect the TX Matrix Plus Router to a Management Console or Auxiliary
Device
Copyright © 2015, Juniper Networks, Inc.
NOTE:
For detailed instructions on reinstalling TX Matrix Plus router
components, see the TX Matrix Plus Router Hardware Guide.
NOTE:
Make sure that all empty slots are covered with a blank panel before
operating the TX Matrix Plus router.
Slide each component into the chassis evenly so that it does not become stuck or
1.
damaged.
Tighten the captive screws for each component.
2.
Attach one or more management console or auxiliary devices to the Routing Engine ports
on each TXP-CB for management and service operations (see
To connect the cables for a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If necessary, turn off the power to the console or auxiliary device.
2.
Plug one end (shown in
3.
AUX
port on the TXP-CB in slot
into the TXP-CB in slot
Attach the other end of the cable to the console or auxiliary device.
4.
Plug one end of another serial cable into the
5.
slot
. This port connects to the Routing Engine installed into the TXP-CB in slot
CB1
.
CB1
Attach the other end of the cable to the console or auxiliary device.
6.
NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 11 on page
22) of a serial cable into the
CB0
. This port connects to the Routing Engine installed
.
CB0
CONSOLE
Reinstall TX Matrix Plus Components
Figure 10 on page
22).
CONSOLE
or
AUX
port on the TXP-CB in
or
21
Advertisement
Table of Contents
