TX Matrix Hardware Guide
Removing the TX Matrix Craft Interface
Installing the TX Matrix Craft Interface
246
To remove the craft interface (see Figure 105 on page 246):
NOTE: Removing the front air filter might make it easier to grasp the craft
interface. For instructions, see "Removing the TX Matrix Front Air Filter" on
page 241.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Completely loosen the screws at the four corners of the craft interface using a Phillips
2.
(+) screwdriver, number 1.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
3.
out of the chassis.
CAUTION: Do not leave the craft interface slot empty for more than a short
time while the TX Matrix router is operational. The craft interface must remain
in the chassis for proper airflow.
Figure 105: Removing the Craft Interface
To install the craft interface (see Figure 106 on page 247):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Grasping the craft interface by the top and bottom edges, press it into place.
2.
Tighten the screws at the corners of the craft interface.
3.
Copyright © 2010, Juniper Networks, Inc.