Set Mld Interfacemode - NETGEAR M6100 Series Reference Manual

MLD Snooping supports the following activities:
• Validation of address version, payload length consistencies and discarding of the frame
upon error.
• Maintenance of the forwarding table entries based on the MAC address versus the IPv6
address.
• Flooding of unregistered multicast data packets to all ports in the VLAN.
Default disabled
Format
set mld vlan-id
Mode Global Config
Interface Config
VLAN Mode
no set mld
Use this command to disable MLD Snooping on the system.
Format
no set mld vlan-id
Mode Global Config
Interface Config
VLAN Mode

set mld interfacemode

Use this command to enable MLD Snooping on all interfaces. If an interface has MLD
Snooping enabled and you enable this interface for routing or enlist it as a member of a
port-channel (LAG), MLD Snooping functionality is disabled on that interface. MLD Snooping
functionality is re-enabled if you disable routing or remove port-channel (LAG) membership
from an interface that has MLD Snooping enabled.
Default disabled
Format
set mld interfacemode
Mode Global Config
no set mld interfacemode
Use this command to disable MLD Snooping on all interfaces.
Format
no set mld interfacemode
Mode Global Config
M6100 Series Switches
Switching Commands
526