Show Dhcp Lease - NETGEAR M6100 Series Reference Manual

form an adjacency (unless OSPF has been instructed to ignore differences in IP MTU with
the ip ospf mtu-ignore command.)
Note: The IP MTU size refers to the maximum size of the IP packet (IP
Header + IP payload). It does not include any extra bytes that may be
required for Layer-2 headers. To receive and process packets, the
Ethernet MTU (see
of the Ethernet header.
Default 1500 bytes
Format
ip mtu size
Mode Interface Config
no ip mtu
This command resets the ip mtu to the default value.
Format
no ip mtu
Mode Interface Config
encapsulation
This command configures the link layer encapsulation type for the packet on an interface or
range of interfaces. The encapsulation type can be ethernet or snap.
Default ethernet
Format
encapsulation {ethernet | snap}
Mode Interface Config
Note: Routed frames are always ethernet encapsulated when a frame is
routed to a VLAN.

show dhcp lease

This command displays a list of IPv4 addresses currently leased from a DHCP server on a
specific in-band interface or all in-band interfaces. This command does not apply to service
or network ports.
Format
show dhcp lease [interface unit/slot/port]
Modes Privileged EXEC
M6100 Series Switches
mtu on page 325) must take into account the size
Routing Commands
635