Ospfv3 Show Commands; Show Ipv6 Ospf - NETGEAR M6100 Series Reference Manual

Format
clear ipv6 ospf stub-router
Mode Privileged EXEC

OSPFv3 Show Commands

show ipv6 ospf

This command displays information relevant to the OSPF router.
Format
show ipv6 ospf
Mode Privileged EXEC
User EXEC
Note: Some of the information below displays only if you enable OSPF and
configure certain features.
Term Definition
Router ID A 32-bit integer in dotted decimal format identifying the router, about which information is displayed.
This is a configured value.
OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a
configured value.
External LSDB The maximum number of non-default AS-external-LSAs entries that can be stored in the link-state
Limit database.
Exit Overflow The number of seconds that, after entering overflow state, a router will attempt to leave overflow
Interval state.
SPF Start Time The number of milliseconds the SPF calculation is delayed if no SPF calculation has been
scheduled during the current "wait interval".
SPF Hold Time The number of milliseconds of the initial wait interval.
SPF Maximum The maximum number of milliseconds of the "wait interval".
Hold Time
LSA Refresh Group The size of the LSA refresh group window, in seconds.
Pacing Time
AutoCost Ref BW Shows the value of the auto-cost reference bandwidth configured on the router.
Default Passive Shows whether the interfaces are passive by default.
Setting
Maximum Paths The maximum number of paths that OSPF can report for a given destination.
M6100 Series Switches
IPv6 Commands
954