Sntp Client Mode; Sntp Client Port; Sntp Unicast Client Poll-Interval - NETGEAR M6100 Series Reference Manual

sntp client mode

This command enables Simple Network Time Protocol (SNTP) client mode and may set the
mode to either broadcast or unicast.
Default disabled
Format
sntp client mode [broadcast | unicast]
Mode Global Config
no sntp client mode
This command disables Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode Global Config

sntp client port

This command sets the SNTP client port ID to a value in the range 1025–65535, represented
by the portid argument. The default value is 0, which means that the SNTP port is not
configured by the user. In the default case, the actual client port value used in SNTP packets
is assigned by the underlying OS.
Default 0
Format
sntp client port portid
Mode Global Config
no sntp client port
This command resets the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config

sntp unicast client poll-interval

This command sets the poll interval for SNTP unicast clients in seconds as a power of two
where poll-interval can be a value from 6 to 10.
Default 6
Format
sntp unicast client poll-interval poll-interval
Mode Global Config
M6100 Series Switches
Utility Commands
208