Show Authentication Authentication-History; Show Authentication Interface - NETGEAR M6100 Series Reference Manual

no authentication timer restart
This command sets the reauthentication value to the default value of 3600 seconds.
Format
no authentication timer restart
Mode Interface Config

show authentication authentication-history

Use this command to display information about the authentication history for a specified
interface.
Format
show authentication authentication-history unit/slot/port
Mode Privileged EXEC
Term
Time Stamp
Interface
MAC-Address
Auth Status Method
Command example:
Time Stamp
--------------------- --------- ----------------- ------ ------------
Jul 21 1919 15:06:15

show authentication interface

Use this command to display authentication method information either for all interfaces or a
specified port.
Format
show authentication interface {all | unit/slot/port}
Mode Privileged EXEC
The following information is displayed for each interface.
Term
Interface
Authentication Restart timer
Configured method order
M6100 Series Switches
Definition
The time of the authentication.
The interface.
The MAC address for the interface.
The authentication method and status for the interface.
Interface MAC-Address
1/0/1 00:00:00:00:00:01 Authorized
Definition
The interface for which authentication configuration information is being displayed.
The time, in seconds, after which reauthentication starts.
The order of authentication methods used on a port.
Switching Commands
406
Auth Status Method
802.1X