Ip Arp Inspection Trust; Ip Arp Inspection Limit - NETGEAR M6100 Series Reference Manual

no ip arp inspection vlan logging
Use this command to disable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Format
no ip arp inspection vlan vlan-list logging
Mode Global Config

ip arp inspection trust

Use this command to configure an interface or range of interfaces as trusted for Dynamic
ARP Inspection.
Default
enabled
Format
ip arp inspection trust
Mode Interface Config
no ip arp inspection trust
Use this command to configure an interface as untrusted for Dynamic ARP Inspection.
Format
no ip arp inspection trust
Mode Interface Config

ip arp inspection limit

Use this command to configure the rate limit and burst interval values for an interface or
range of interfaces. Configuring none for the limit means the interface is not rate limited for
Dynamic ARP Inspections. The maximum pps value shown in the range for the rate option
might be more than the hardware allowable limit. Therefore you need to understand the
switch performance and configure the maximum rate pps accordingly.
Note: The user interface accepts a rate limit for a trusted interface, but the
limit is not enforced unless the interface is configured to be untrusted.
Default 15 pps for rate and 1 second for burst-interval.
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode Interface Config
M6100 Series Switches
Switching Commands
500