Routing/Ipv6 Routing - NETGEAR M6100 Series Reference Manual

Routing/IPv6 Routing

Table 58. DHCP Relay Log Messages
Component Message
DHCP relay REQUEST hops field more than config value
DHCP relay Request's seconds field less than the config
value
DHCP relay processDhcpPacket: invalid DHCP packet type:
%u\n
Table 59. OSPFv2 Log Messages
Component Message
OSPFv2 Best route client deregistration failed for OSPF
Redist
OSPFv2 XX_Call() failure in _checkTimers for thread
0x869bcc0
OSPFv2 Warning: OSPF LSDB is 90% full (22648 LSAs). OSPFv2 limits the number of Link State
OSPFv2 The number of LSAs, 25165, in the OSPF LSDB
has exceeded the LSDB memory allocation.
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1171
Cause
The DHCP relay agent has processed a DHCP
request whose HOPS field is larger than the
maximum value allowed. The relay agent will not
forward a message with a hop count greater than
4.
The DHCP relay agent has processed a DHCP
request whose SECS field is larger than the
configured minimum wait time allowed.
The DHCP relay agent has processed an invalid
DHCP packet. Such packets are discarded by
the relay agent.
Cause
OSPFv2 registers with the IPv4 routing table
manager ("RTO") to be notified of best route
changes. There are cases where OSPFv2
deregisters more than once, causing the second
deregistration to fail. The failure is harmless.
An OSPFv2 timer has fired but the message
queue that holds the event has filled up. This is
normally a fatal error.
Advertisements (LSAs) that can be stored in the
link state database (LSDB). When the database
becomes 90 or 95 percent full, OSPFv2 logs this
warning. The warning includes the current size of
the database.
When the OSPFv2 LSDB becomes full, OSPFv2
logs this message. OSPFv2 reoriginates its
router LSAs with the metric of all non-stub links
set to the maximum value to encourage other
routers to not compute routes through the
overloaded router.