Set Garp Timer Leave - NETGEAR M6100 Series Reference Manual

command has an effect only when GVRP is enabled. The time is from 10 to 100
centiseconds. The value 20 centiseconds is 0.2 seconds.
Default 20
Format
set garp timer join centiseconds
Mode Interface Config
Global Config
no set garp timer join
This command sets the GVRP join time to the default and only has an effect when GVRP is
enabled.
Format
no set garp timer join
Mode Interface Config
Global Config

set garp timer leave

This command sets the GVRP leave time for one interface, a range of interfaces, or all
interfaces or all ports and only has an effect when GVRP is enabled. Leave time is the time to
wait after receiving an unregister request for a VLAN or a multicast group before deleting the
VLAN entry. This can be considered a buffer time for another station to assert registration for
the same attribute in order to maintain uninterrupted service. The leave time is 20 to 600
centiseconds. The value 60 centiseconds is 0.6 seconds. The leave time must be greater
than or equal to three times the join time.
Default 60
Format
set garp timer leave centiseconds
Mode Interface Config
Global Config
no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only
has an effect when GVRP is enabled.
Format
no set garp timer leave
Mode Interface Config
Global Config
M6100 Series Switches
Switching Commands
390