Serviceability Packet Tracing Commands; Show Ip Address-Conflict; Clear Ip Address-Conflict-Detect; Capture Start - NETGEAR M6100 Series Reference Manual

show ip address-conflict

This command displays the status information corresponding to the last detected address
conflict.
Format
show ip address-conflict
Modes Privileged EXEC
Term
Address Conflict Detection Status
Last Conflicting IP Address
Last Conflicting MAC Address
Time Since Conflict Detected

clear ip address-conflict-detect

This command clears the detected address conflict status information.
Format
clear ip address-conflict-detect
Modes Privileged EXEC

Serviceability Packet Tracing Commands

These commands improve the capability of network engineers to diagnose conditions
affecting their NETGEAR Managed Switch product.
CAUTION:
The output of debug commands can be long and may adversely affect
system performance.

capture start

Use the capture start command to manually start capturing CPU packets for packet
trace.
The packet capture operates in three modes:
• capture file
• remote capture
• capture line
M6100 Series Switches
Definition
Identifies whether the switch has detected an address conflict on any IP address.
The IP Address that was last detected as conflicting on any interface.
The MAC Address of the conflicting host that was last detected on any interface.
The time in days, hours, minutes and seconds since the last address conflict was
detected.
Utility Commands
236