Show Ipv6 Route - NETGEAR M6100 Series Reference Manual

M6100 Series Switches
BGP Router ID ................................. 1.1.1.1
Local AS Number ............................... 1
BGP Admin Mode ................................ Enable
Maximum Paths ................................. Internal 1, External 1
Always compare MED ............................ FALSE
Maximum AS Path Length ........................ 75
Fast Internal Failover ........................ Enable
Fast External Failover ........................ Enable
Distance ...................................... Ext 20, Int 200, Local 200
Prefixes Originated:
2005::/64 (active)
3012::/48
Neighbors:
172.20.1.100
Filter List In........................... 1
Filter List Out........................... 2
Prefix List In............................ PfxList2
Prefix List Out........................... PfxList3
Route Map In.............................. rmapUp
Route Map Out............................. rmapDown
Routing Protocol .............................. OSPFv3
Router ID ..................................... 1.1.1.1
OSPF Admin Mode ............................... Enable
Maximum Paths ................................. 4
Distance ...................................... Intra 110 Inter 110 Ext 110
Default Route Advertise ....................... Disabled
Always ........................................ FALSE
Metric ........................................ Not configured
Metric Type ................................... External Type 2
Number of Active Areas ........................ 0 (0 normal, 0 stub, 0 nssa)
ABR Status .................................... Disable
ASBR Status ................................... Disable

show ipv6 route

This command displays the IPv6 routing table The ipv6-address specifies a specific IPv6
address for which the best-matching route would be displayed. The
ipv6-prefix/ipv6-prefix-length specifies a specific IPv6 network for which the
matching route would be displayed.
IPv6 Commands
916