Ip Pim Dr-Priority; Ip Pim Join-Prune-Interval - NETGEAR M6100 Series Reference Manual

no ip pim bsr-candidate
Use this command to remove the configured PIM Candidate BSR router.
Format
no ip pim bsr-candidate interface {unit/slot/port | vlan vlan-id}
Mode Global Config

ip pim dr-priority

Use this command to set the priority value for which a router is elected as the designated
router (DR). The priority argument is a value in the range of 0–2147483647.
Note: This command takes effect only when Sparse mode is enabled in the
Global mode.
Default 1
Format
ip pim dr-priority priority
Mode Interface Config
Command example:
(NETGEAR) (Interface 1/0/1) #ip pim dr-priority 10
no ip pim dr-priority
Use this command to return the DR Priority on the specified interface to its default value.
Format
no ip pim dr-priority
Mode Interface Config

ip pim join-prune-interval

Use this command to configure the frequency of PIM Join/Prune messages on a specified
interface. The join/prune interval is specified in seconds. The seconds argument can be
configured as a value from 0 to 18000 seconds.
Note: This command takes effect only when PIM-SM is configured as the
PIM mode.
M6100 Series Switches
IP Multicast Commands
1085