Show Ipv6 Neighbors - NETGEAR M6100 Series Reference Manual

ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id
parameter is a number in the range of 1–4093.
Format
show ipv6 dhcp [interface {unit/slot/port | vlan vland-id}]
Modes Privileged EXEC
Term
Mode
State
Server DUID
T1 Time
T2 Time
Interface IAID
Leased Address
Preferred Lifetime
Valid Lifetime
Renew Time
Expiry Time

show ipv6 neighbors

Use this command to display information about the IPv6 neighbors.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id
parameter is a number in the range of 1–4093.
The tunnel keyword with the number variable specifies the IPv6 tunnel interface and is a
number in the range 0–7.
Format
show ipv6 neighbor [interface {unit/slot/port | vlan vlan-id | tunnel number
| ipv6-address]
Mode Privileged EXEC
M6100 Series Switches
Definition
Displays whether the specified interface is in Client mode or not.
State of the DHCPv6 Client on this interface.The valid values are: INACTIVE, SOLICIT,
REQUEST, ACTIVE, RENEW, REBIND, RELEASE.
DHCPv6 Unique Identifier of the DHCPv6 Server on this interface.
The T1 time specified by the DHCPv6 server. After the client has held the address for this
length of time, the client tries to renew the lease.
The T2 time specified by the DHCPv6 server. If the lease renewal fails, then when the
client has held the lease for this length of time, the client sends a Rebind message to the
server.
An identifier for an identity association chosen by this client.
The IPv6 address leased by the DHCPv6 Server for this interface.
The preferred lifetime of the IPv6 address, as defined in RFC 2462.
The valid lifetime of the IPv6 address, as defined by RFC 2462.
The time until the client tries to renew the lease
The time until the address expires.
IPv6 Commands
913