Chapter 15 Ipv6 Multicast Commands - NETGEAR M6100 Series Reference Manual

IPv6 Multicast Commands
15.
The entire IPv6 Multicast commands section is Enterprise-only. This chapter describes the IPv6
Multicast commands available in the NETGEAR Managed Switch CLI.
The chapter contains the following sections:
• IPv6 Multicast Forwarder
• IPv6 PIM Commands
• IPv6 MLD Commands
• IPv6 MLD-Proxy Commands
Note: No specific command exists to enable multicast for IPv6. If you
enable multicast with a global config command, multicast is enabled
for both IPv4 and IPv6.
The commands in this chapter are in one of three functional groups:
• Show commands. Display switch settings, statistics, and other information.
• Configuration commands. Configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands. Clear some or all of the settings to factory defaults.
1110
15