Show Fip-Snooping - NETGEAR M6100 Series Reference Manual

This command can only be entered after FIP snooping is enabled using the
priority-flow-control mode
Default Configuration as a host-facing interface.
Format
fip-snooping port-mode fcf
Mode Interface Config
Parameter Description
fcf Fibre Channel Fabric
Command example:
The following example configures an interface to be connected to an FCF switch:
(Config)# interface 1/0/1
(Interface 1/0/1)# fip-snooping port-mode fcf
(Interface 1/0/1)# exit
no fip-snooping port-mode
Use this command to set the interface to be connected towards the host.
Format
no fip-snooping port-mode
Mode Interface Config
Command example:
The following example sets the interface to be connected towards the host:
(Config)# interface 1/0/1
(Interface 1/0/1)# no fip-snooping port-mode fcf
(Interface 1/0/1)# exit

show fip-snooping

Use the show fip-snooping sessions command in User EXEC or Privileged EXEC
mode to display information about the global FIP snooping configuration and status.
Format
show fip-snooping
Mode User EXEC
Privileged EXEC
M6100 Series Switches
command. Otherwise, it does not appear in the CLI syntax tree.
Data Center Commands
601