Port Lacpmode Enable All; Port Lacptimeout (Interface Config) - NETGEAR M6100 Series Reference Manual

port lacpmode enable all

This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format
port lacpmode enable all
Mode Global Config
no port lacpmode enable all
This command disables Link Aggregation Control Protocol (LACP) on all ports.
Format
no port lacpmode enable all
Mode Global Config

port lacptimeout (Interface Config)

This command sets the timeout on a physical interface or range of interfaces of a particular
device type (actor or partner) to either long or short timeout.
Default long
Format
port lacptimeout {actor | partner} {long | short}
Mode Interface Config
no port lacptimeout
This command sets the timeout back to its default value on a physical interface of a particular
device type (actor or partner).
Format
no port lacptimeout {actor | partner}
Mode Interface Config
Note: Both the no portlacptimeout and the no lacp actor admin
state commands set the values back to default, regardless of the
command used to configure the ports. Consequently, both commands
display in the output of the show running-config command.
M6100 Series Switches
Switching Commands
454