Diffserv Show Commands; Show Class-Map - NETGEAR M6100 Series Reference Manual

Note: This command causes a service to remove its reference to the policy.
This command effectively disables DiffServ on an interface in the
inbound direction or an interface in the outbound direction. There is
no separate interface administrative 'mode' command for DiffServ.
Format
no service-policy {in | out} policymapname
Modes Global Config
Interface Config

DiffServ Show Commands

Use the DiffServ show commands to display configuration and status information for classes,
policies, and services. You can display DiffServ information in summary or detailed formats.
The status information is only shown when the DiffServ administrative mode is enabled.

show class-map

This command displays all configuration information for the specified class. The
class-name is the name of an existing DiffServ class.
Format
show class-map class-name
Modes Privileged EXEC
User EXEC
If the class-name is specified the following fields are displayed.
Term Definition
Class Name The name of this class.
Class Type A class type of all means every match criterion defined for the class is evaluated simultaneously and
must all be true to indicate a class match.
Class Layer3 The Layer 3 protocol for this class. Possible values are IPv4 and IPv6.
Protocol
Match Criteria The Match Criteria fields are only displayed if they have been configured. Not all platforms support
all match criteria values. They are displayed in the order entered by the user. The fields are
evaluated in accordance with the class type. The possible Match Criteria fields are: Destination IP
Address, Destination Layer 4 Port, Destination MAC Address, Ethertype, Source MAC Address,
VLAN, Class of Service, Every, IP DSCP, IP Precedence, IP TOS, Protocol Keyword, Reference
Class, Source IP Address, and Source Layer 4 Port.
Values The values of the Match Criteria.
M6100 Series Switches
Quality of Service Commands
1021