Mark Ip-Dscp; Mark Ip-Precedence - NETGEAR M6100 Series Reference Manual

mark ip-dscp

This command marks all packets for the associated traffic stream with the specified IP DSCP
value. The dscpval value is specified as either an integer from 0 to 63, or symbolically
through one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, or ef
Format
mark ip-dscp dscpval
Mode Policy-Class-Map Config
Incompatibilities Drop, Mark CoS, Mark IP Precedence, Police

mark ip-precedence

This command marks all packets for the associated traffic stream with the specified IP
Precedence value. The IP Precedence value argument is an integer from 0 to 7.
Note: This command may not be used on IPv6 classes. IPv6 does not have
a precedence field.
Format
mark ip-precedence value
Mode Policy-Class-Map Config
Incompatibilities Drop, Mark CoS, Mark IP Precedence, Police
Policy Type In
police-simple
This command is used to establish the traffic policing style for the specified class. The simple
form of the police command uses a single data rate and burst size, resulting in two
outcomes: conform and violate. The conforming data rate is specified in kilobits-per-second
(Kbps) and is an integer from 1 to 4294967295. The conforming burst size is specified in
kilobytes (KB) and is an integer from 1 to 128.
For each outcome, the only possible actions are drop, set-cos-as-sec-cos, set-cos-transmit,
set-sec-cos-transmit, set-dscp-transmit, set-prec-transmit, or transmit. In this simple form of
the police command, the conform action defaults to transmit and the violate action defaults
to drop. These actions can be set with this command once the style is configured.
For set-dscp-transmit, a value is required and is specified as either an integer from 0 to
63, or symbolically through one of the following keywords: af11, af12, af13, af21, af22,
af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7,
or ef.
For set-prec-transmit, an IP Precedence value is required and is specified as an
integer from 0-7.
M6100 Series Switches
Quality of Service Commands
1017
.