Prefix-Suppression (Router Ospf Config) - NETGEAR M6100 Series Reference Manual

Default -1
Format
external-lsdb-limit limit
Mode Router OSPF Config
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
no external-lsdb-limit
Mode Router OSPF Config
log-adjacency-changes
To enable logging of OSPFv2 neighbor state changes, use the log-adjacency-changes
command in router configuration mode. State changes are logged with INFORMATIONAL
severity.
Default Adjacency state changes are logged, but without the detail option.
Format
log-adjacency-changes [detail]
Mode OSPFv2 Router Configuration
Parameter Description
detail (Optional) When this keyword is specified, all adjacency state changes are logged. Otherwise,
OSPF only logs transitions to FULL state and when a backwards transition occurs.
no log-adjacency-changes
Use the no form of the command to disable state change logging.
Format
no log-adjacency-changes [detail]
Mode OSPFv2 Router Configuration

prefix-suppression (Router OSPF Config)

This command suppresses the advertisement of all the IPv4 prefixes except for prefixes that
are associated with secondary IPv4 addresses, loopbacks, and passive interfaces from the
OSPFv2 router advertisements.
To suppress a loopback or passive interface, use the
interface configuration mode. Prefixes associated with secondary IPv4 addresses can never
be suppressed.
M6100 Series Switches
ip ospf prefix-suppression
Routing Commands
716
command in