Ipv6 Ospf Area; Ipv6 Ospf Cost; Ospfv3 Interface Commands - NETGEAR M6100 Series Reference Manual

Format
no trapflags {all | errors {all | authentication-failure | bad-packet |
config-error | virt-authentication-failure | virt-bad-packet |
virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all |
lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | state-change {all | if-state-change | neighbor-state-change |
virtif-state-change | virtneighbor-state-change}}
Mode Router OSPFv3 Config

OSPFv3 Interface Commands

ipv6 ospf area

This command sets the OSPF area to which the specified router interface or range of
interfaces belongs. It also enables OSPF on the specified router interface or range of
interfaces. The area-id is a 32-bit integer, formatted as a 4-digit dotted-decimal number or
a decimal value in the range of 0-4294967295. The area-id uniquely identifies the area to
which the interface connects. Assigning an area ID for an area that does not yet exist, causes
the area to be created with default values.
Format
ipv6 ospf area area-id
Mode Interface Config

ipv6 ospf cost

This command configures the cost on an OSPF interface or range of interfaces. The cost
parameter has is in the range of 1 to 65535.
Default 10
Format
ipv6 ospf cost cost
Mode Interface Config
no ipv6 ospf cost
This command configures the default cost on an OSPF interface.
Format
no ipv6 ospf cost
Mode Interface Config
M6100 Series Switches
IPv6 Commands
944