Mvr Immediate; Mvr Type - NETGEAR M6100 Series Reference Manual

no mvr vlan
This command sets the MVR multicast VLAN to the default value.
Format
no mvr vlan
Mode Global Config

mvr immediate

This command enables MVR immediate leave mode. MVR provides two modes of operating
with the IGMP Leave messages: normal leave and immediate leave.
• In normal leave mode, when a leave is received, the general IGMP query is sent from a
Layer 2 switch to the receiver port, where the leave was received. Then reports are
received from other interested hosts that are also connected to that port, for example,
using hub.
• In immediate leave mode, when a leave is received, the switch is immediately
reconfigured not to forward a specific multicast stream to the port where a message is
received. This mode is used only for ports where only one client might be connected.
Default Disabled
Format
mvr immediate
Mode Interface Config
no mvr immediate
This command sets the MVR multicast VLAN to the default value.
Format
no mvr immediate
Mode Interface Config

mvr type

This command sets the MVR port type. When a port is set as source, it is the port to which
the multicast traffic flows using the multicast VLAN. When a port is set to receiver, it is the
port where a listening host is connected to the switch.
Default none
Format
mvr type {receiver | source}
Mode Interface Config
M6100 Series Switches
Switching Commands
508