Serviceport Ipv6 Gateway; Serviceport Ipv6 Neighbor - NETGEAR M6100 Series Reference Manual

serviceport ipv6 gateway

Use this command to configure IPv6 gateway information (that is, default routers information)
for the service port.
Note: Only a single IPv6 gateway address can be configured for the service
port. There may be a combination of IPv6 prefixes and gateways that
are explicitly configured and those that are set through auto-address
configuration with a connected IPv6 router on their service port
interface.
Format
serviceport ipv6 gateway gateway-address
Mode Privileged EXEC
Parameter Description
gateway-address Gateway address in IPv6 global or link-local address format.
no serviceport ipv6 gateway
Use this command to remove IPv6 gateways on the service port interface.
Format
no serviceport ipv6 gateway
Mode Privileged EXEC

serviceport ipv6 neighbor

Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for the service
port. If an IPv6 neighbor already exists in the neighbor table, the entry is automatically
converted to a static entry. Static entries are not modified by the neighbor discovery process.
They are, however, treated the same for IPv6 forwarding. Static IPv6 neighbor entries are
applied to the hardware when the corresponding interface is operationally active.
Format
serviceport ipv6 neighbor ipv6-address macaddr
Mode Privileged EXEC
Parameter Description
ipv6-address The IPv6 address of the neighbor or interface.
macaddr The link-layer address.
M6100 Series Switches
IPv6 Commands
885