Area Nssa Translator-Stab-Intv (Ospf); Area Range (Ospf) - NETGEAR M6100 Series Reference Manual

no area nssa translator-role (OSPF)
This command disables the nssa translator role from the specified area id.
Format
no area area-id nssa translator-role {always | candidate}
Mode Router OSPF Config

area nssa translator-stab-intv (OSPF)

This command configures the translator stabilityinterval of the NSSA. The
stabilityinterval is the period of time that an elected translator continues to perform its
duties after it determines that its translator status has been deposed by another router.
Format
area area-id nssa translator-stab-intv stabilityinterval
Mode Router OSPF Config
no area nssa translator-stab-intv (OSPF)
This command disables the nssa translator's stabilityinterval from the specified area
id.
Format
no area area-id nssa translator-stab-intv stabilityinterval
Mode Router OSPF Config

area range (OSPF)

Use the area range command in Router Configuration mode to configure a summary prefix
that an area border router advertises for a specific area.
Default No area ranges are configured by default. No cost is configured by default.
Format
area area-id range ip-address netmask {summarylink | nssaexternallink}
[advertise | not-advertise] [cost cost]
Mode OSPFv2 Router Configuration
Parameter Description
area-id The area identifier for the area whose networks are to be summarized.
prefix netmask The summary prefix to be advertised when the ABR computes a route to one or more networks
within this prefix in this area.
summarylink When this keyword is given, the area range is used when summarizing prefixes advertised in type 3
summary LSAs.
nssaexternallink When this keyword is given, the area range is used when translating type 7 LSAs to type 5 LSAs.
advertise [Optional] When this keyword is given, the summary prefix is advertised when the area range is
active. This is the default.
M6100 Series Switches
Routing Commands
706