Poe Timer Schedule Name; Poe Usagethreshold - NETGEAR M6100 Series Reference Manual

Format
poe reset
Mode Global Config
Interface Config

poe timer schedule name

Use this command to allow you to attach a timer schedule to a PoE port.
You can define a time schedule using the existing time range commands. This schedule has
start and stop times. When this timer schedule is applied to a PoE-enabled port, the
capability of the port to deliver power is affected. At the scheduled start time, the PoE port is
disabled such that it cannot deliver any power. At the scheduled stop time, the PoE port is
reenabled so that it can deliver power.
Note: For information about creating a timer schedule, see
Commands for Time-Based ACLs on page
Format
poe timer schedule name
Mode Interface Config
no poe timer schedule name
Use this command to detach the schedule from the port.
Format
no poe timer schedule
Mode Interface Config

poe usagethreshold

Use this command to set a threshold (as a percentage) for the total amount of power that can
be delivered by the switch. For example, if the switch can deliver up to a maximum of 300
watts, a usage threshold of 90 percent ensures that only 270 watts are used for delivering
power to devices. This ensures that more power is not drawn than the switch can provide.
When the usage threshold is set, all the PDs are brought down and then brought back up. If
the consumed power is less than the threshold power (in the preceding case, 270 watts),
then the devices continue to power up. If the consumed power is 269 watts or less, the next
device is powered up. The moment consumed power exceeds the threshold power (270
watts), no other devices can power up.
This command allows you to set the usage threshold based on each individual PoE unit or all
PoE units.
M6100 Series Switches
Power over Ethernet Commands
1147
Time Range
1054.