Default Metric (Ipv6 Address Family Config); Distance (Bgp Router Config) - NETGEAR M6100 Series Reference Manual

Default No default metric is set and no MED is included in redistributed routes.
Format
default-metric value
Mode BGP Router Config
Parameter Description
value The value to set as the MED. The range is 1 to 4,294,967,295.
no default metric (BGP Router Config)
Use this command to delete the default for the metric of redistributed routes.
Format
no default-metric
Mode BGP Router Config

default metric (IPv6 Address Family Config)

Use this command to set the metric of redistributed IPv6 routes when a metric has been
configured in the command
Default No default metric is set and no MED is included in redistributed routes.
Format
default-metric value
Mode IPv6 Address Family Config
Parameter Description
value The value to set as the MED. The range is 1 to 4,294,967,295.
no default metric (IPv6 Address Family Config)
Use this command to delete the default for the metric of redistributed IPv6 routes.
Format
no default-metric
Mode IPv6 Address Family Config

distance (BGP Router Config)

Use this command to set the preference (also known as administrative distance) of BGP
routes to specific destinations. You may enter up to 128 instances of this command. Two
instances of this command may not have the same prefix and wildcard mask. If a distance
command is configured that matches an existing distance command's prefix and wildcard
mask, the new command replaces the existing command. There can be overlap between the
prefix and mask configured for different commands. When there is overlap, the command
M6100 Series Switches
redistribute (BGP Router Config)
Border Gateway Protocol Commands
810
on page 839.