Ospfv3 Commands; Ipv6 Router Ospf; Area Default-Cost (Ospfv); Area Nssa (Ospfv) - NETGEAR M6100 Series Reference Manual

OSPFv3 Commands

This section describes the commands you use to configure OSPFv3, which is a link-state
routing protocol that you use to route traffic within a network. This section includes the
following subsections:
•

Global OSPFv3 Commands

• OSPFv3 Interface Commands
• OSPFv3 Graceful Restart Commands
• OSPFv3 Stub Router Commands
• OSPFv3 Show Commands
Global OSPFv3 Commands

ipv6 router ospf

Use this command to enter Router OSPFv3 Config mode.
Format
router ospf
Mode Global Config
area default-cost (OSPFv3)
This command configures the monetary default cost for the stub area. For the value
argument, you must specify an integer value between 1–16777215.
Format
area area-id default-cost value
Mode Router OSPFv3 Config
area nssa (OSPFv3)
This command configures the specified area-id to function as an NSSA.
Format
area area-id nssa
Mode Router OSPFv3 Config
no area nssa
This command disables nssa from the specified area id.
Format
no area area-id nssa
Mode Router OSPFv3 Config
M6100 Series Switches
on page 928
on page 944
on page 949
on page 952
on page 954
IPv6 Commands
928