Show Lldp Remote-Device - NETGEAR M6100 Series Reference Manual

The table contains the following column headings.
Term Definition
Interface The interface in unit/slot/port format.
TX Total Total number of LLDP packets transmitted on the port.
RX Total Total number of LLDP packets received on the port.
Discards Total number of LLDP frames discarded on the port for any reason.
Errors The number of invalid LLDP frames received on the port.
Ageouts Total number of times a complete remote data entry was deleted for the port because the Time to
Live interval expired.
TVL Discards The number of TLVs discarded.
TVL Unknowns Total number of LLDP TLVs received on the port where the type value is in the reserved range, and
not recognized.
TLV MED The total number of LLDP-MED TLVs received on the interface.
TLV 802.1 The total number of LLDP TLVs received on the interface which are of type 802.1.
TLV 802.3 The total number of LLDP TLVs received on the interface which are of type 802.3.

show lldp remote-device

Use this command to display summary information about remote devices that transmit
current LLDP data to the system. You can show information about LLDP remote data
received on all ports or on a specific port.
Format
show lldp remote-device {unit/slot/port | all}
Mode Privileged EXEC
Term Definition
Local Interface The interface that received the LLDPDU from the remote device.
RemID An internal identifier to the switch to mark each remote device to the system.
Chassis ID The ID that is sent by a remote device as part of the LLDP message, it is usually a MAC address of
the device.
Port ID The port number that transmitted the LLDPDU.
System Name The system name of the remote device.
Command example:
(NETGEAR switch) #show lldp remote-device all
LLDP Remote Device Summary
M6100 Series Switches
Switching Commands
547