Ipv6 Mld Last-Member-Query-Count; Ipv6 Mld Version; Show Ipv6 Mld Groups - NETGEAR M6100 Series Reference Manual

ipv6 mld last-member-query-count

Use this command to set the number of listener-specific queries sent before the router
assumes that there are no local members on an interface or range of interfaces. The range
for the number argument is 1 to 20.
Default 2
Format
ipv6 mld last-member-query-count number
Mode Interface Config
no ipv6 mld last-member-query-count
Use this command to reset the last-member-query-count of the interface to the default
value.
Format
no ipv6 mld last-member-query-count
Mode Interface Config

ipv6 mld version

Use this command to configure the MLD version that the interface uses.
Default 2
Format
ipv6 mld version {1 | 2}
Mode Interface Config
no ipv6 mld version
This command resets the MLD version used by the interface to the default value.
Format
no ipv6 mld
Mode Interface Config

show ipv6 mld groups

Use this command to display information about multicast groups that MLD reported. The
information is displayed only when MLD is enabled on at least one interface. If MLD was not
enabled on even one interface, there is no group information to be displayed.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter
is a number in the range of 1–4093. You can also specify a group address
(group-address).
M6100 Series Switches
IPv6 Multicast Commands
1131