Renew Dhcp; Renew Dhcp Network-Port; Renew Dhcp Service-Port; Ip Route - NETGEAR M6100 Series Reference Manual

Hide thumbs Also See for M6100 Series:

Table of Contents

release dhcp unit/slot/port

Privileged EXEC

renew dhcp

Use this command to force the DHCPv4 client to immediately renew an IPv4 address lease

on the specified interface.

This command can be used on in-band ports as well as the service or

network (out-of-band) port.

renew dhcp unit/slot/port

Privileged EXEC

Use this command to renew an IP address on a network port.

renew dhcp network-port

Privileged EXEC

Use this command to renew an IP address on a service port.

renew dhcp service-port

Privileged EXEC

This command configures a static route. The ipaddr parameter is a valid IP address, and

subnetmask is a valid subnet mask. The nexthopip parameter is a valid IP address of the

next hop router. Specifying Null0 as nexthop parameter adds a static reject route. The

optional preference parameter is an integer (value from 1 to 255) that allows you to specify

the preference value (sometimes called administrative distance) of an individual static route.

Among routes to the same destination, the route with the lowest preference value is the route

entered into the forwarding database. By specifying the preference of a static route, you

control whether a static route is more or less preferred than routes from dynamic routing

protocols. The preference also controls whether a static route is more or less preferred than

other static routes to the same destination. A route with a preference of 255 cannot be used

to forward traffic.

M6100 Series Switches

Routing Commands

Table of Contents