Distance Rip; Default-Metric (Rip); Distribute-List Out (Rip) - NETGEAR M6100 Series Reference Manual

default-metric (RIP)

This command is used to set a default for the metric of distributed routes. The value for the
metric argument can be from 0–15.
Format
default-metric metric
Mode Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Format
no default-metric
Mode Router RIP Config

distance rip

This command sets the route preference value of RIP in the router. Lower route preference
values are preferred when determining the best route. A route with a preference of 255
cannot be used to forward traffic. The value for the preference argument can be from
1–255.
Default 15
Format
distance rip preference
Mode Router RIP Config
no distance rip
This command sets the default route preference value of RIP in the router.
Format
no distance rip
Mode Router RIP Config

distribute-list out (RIP)

This command is used to specify the access list to filter routes received from the source
protocol. The value for the access-list argument can be from 1–199.
Default 0
Format
distribute-list access-list out {ospf | bgp | static | connected}
Mode Router RIP Config
M6100 Series Switches
Routing Commands
758