Vpc Domain; Feature Vpc; Peer Detection Enable - NETGEAR M6100 Series Reference Manual

vpc domain

Use this command to enter into VPC configuration mode.
Format
vpc domain id
Mode Global Config

feature vpc

This command enables VPC globally. VPC role election occurs if both VPC and the keepalive
state machine are enabled (see
be configured for role election to occur.
Format
feature vpc
Mode Global Config
no feature vpc
This command disables VPC.
Format
no feature vpc
Mode Global Config

peer detection enable

This command starts the dual control plane detection protocol (DCPDP) on the VPC switch.
The peer VPC switch's IP address must be configured for the DCPDP to start on an VPC
switch.
Default
None
Format
peer detection enable
Mode VPC Config
no peer detection enable
This command disables the dual control plane (DCPDP) detection protocol on the VPC
switch.
Format
no peer detection enable
Mode VPC Config
M6100 Series Switches
peer-keepalive timeout
Switching Commands
463
on page 464). Peer link also has to