Clear Green-Mode Statistics - NETGEAR M6100 Series Reference Manual

Reason................................... Forced
EEE Admin Mode.............................. Enabled
Transmit Idle Time....................... 0
Transmit Wake Time....................... 0
Rx Low Power Idle Event Count............ 0
Rx Low Power Idle Duration (uSec)........ 0
Tx Low Power Idle Event Count............ 0
Tx Low Power Idle Duration (uSec)........ 0
Tw_sys_tx (usec)......................... XX
Tw_sys_tx Echo(usec)..................... XX
Tw_sys_rx (usec)......................... XX
Tw_sys_tx Echo(usec)..................... XX
Fallback Tw_sys (usec)................... XX
Remote Tw_sys_tx (usec).................. XX
Remote Tw_sys_tx Echo(usec).............. XX
Remote Tw_sys_rx (usec).................. XX
Remote Tw_sys_tx Echo(usec).............. XX
Remote fallback Tw_sys (usec)............ XX
Tx DLL enabled........................... Yes
Tx DLL ready............................. Yes
Rx DLL enabled........................... Yes
Rx DLL ready............................. Yes
Cumulative Energy Saving (W * H).......... XX
Time Since Counters Last Cleared......... 1 day 20 hr 47 min 34 sec

clear green-mode statistics

Use this command to clear the following Green Ethernet mode statistics:
• EEE LPI event count and LPI duration
• EEE LPI history table entries
• Cumulative power-savings estimates
You can clear the statistics for a specified port or for all ports.
Note: Executing clear eee statistics clears only the EEE Transmit,
Receive LPI event count, LPI duration, and Cumulative Energy
Savings Estimates of the port. Other status parameters that display
after executing show green-mode (see
page 292) retain their data.
M6100 Series Switches
show green-mode
Utility Commands
296
on