Ipv6 Nd Prefix - NETGEAR M6100 Series Reference Manual

no ipv6 nd suppress-ra
This command enables router transmission on an interface
Format
no ipv6 nd suppress-ra
Mode Interface Config

ipv6 nd prefix

Use the ipv6 nd prefix command to configure parameters associated with prefixes the
router advertises in its router advertisements. The first optional parameter is the valid lifetime
of the router, in seconds in the range of 0–4294967295 seconds.You can specify a value or
indicate that the lifetime value is infinite. The second optional parameter is the preferred
lifetime of the router in seconds in the range of 0–4294967295 seconds.
This command can be used to configure a single interface or a range of interfaces.
The router advertises its global IPv6 prefixes in its router advertisements (RAs). An RA only
includes the prefixes of the IPv6 addresses configured on the interface where the RA is
transmitted. Addresses are configured using the ipv6 address interface configuration
command. Each prefix advertisement includes information about the prefix, such as its
lifetime values and whether hosts should use the prefix for on-link determination or address
auto-configuration. Use the ipv6 nd prefix command to configure these values.
The ipv6 nd prefix command allows you to preconfigure RA prefix values before you
configure the associated interface address. In order for the prefix to be included in RAs, you
must configure an address that matches the prefix using the ipv6 address command.
Prefixes specified using ipv6 nd prefix without associated interface address will not be
included in RAs and will not be committed to the device configuration.
Default valid-lifetime—2592000
preferred-lifetime— 604800
autoconfig—enabled
on-link—enabled
Format
ipv6 nd prefix prefix/prefix_length [{seconds | infinite} {seconds |
infinite}] [no-autoconfig off-link]
Mode Interface Config
no ipv6 nd prefix
This command sets prefix configuration to default values.
Format
no ipv6 nd prefix prefix/prefix_length
Mode Interface Config
M6100 Series Switches
IPv6 Commands
903
.