Show Ip Route - NETGEAR M6100 Series Reference Manual

ospf
Interface
---------
0/25

show ip route

This command displays the routing table. The ip-address specifies the network for which
the route is to be displayed and displays the best matching best-route for the address. The
mask specifies the subnet mask for the given ip-address. When you use the
longer-prefixes keyword, the ip-address and mask pair becomes the prefix, and the
command displays the routes to the addresses that match that prefix. Use the protocol
parameter to specify the protocol that installed the routes. The value for protocol can be
connected, ospf, rip, static, or bgp. Use the all parameter to display all routes
including best and nonbest routes. If you do not use the all parameter, the command
displays only the best route.
Note: If you use the connected keyword for protocol, the all option is
not available because there are no best or nonbest connected routes.
Note: If you use the static keyword for protocol, the description
option is also available, for example: show ip route ip-address
static description. This command shows the description
configured with the specified static route(s).
Format
show ip route [{ip-address [protocol] | {ip-address mask [longer-prefixes]
[protocol] | protocol} [all] | all}]
Modes Privileged EXEC
User EXEC
Term Definition
Route Codes The key for the routing protocol codes that might appear in the routing table output.
The command displays the routing tables in the following format:
show ip route
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Route-Timestamp, Interface,
Truncated
M6100 Series Switches
20 int ext1 ext2 nssa-ext1
Send Recv
---- ----
RIPv2 RIPv2
Routing Commands
644